Diamond Painting Stainless Steel Single Set V3

This tip offers you the same top performance as other popular single setters from a well-known manufacturer and will quickly become your new favorite tool.

Suitable for pins with a round receptacle without thread with an inner diameter of approx. 5.2 mm.

The tip does have a hole in the middle which should make it suitable for e-painters, but I expressly do not recommend this tip for e-painters.

Top Legend:

• V1: Short variant.
  • Resistance to falls and lateral loads: Low
  • Tested side load approx. 1kg.

• V2: Long variant.
  • Resistance to falls and lateral loads: Improved
  • Tested side load approx. 2kg.

• V3: Medium variant.
  • Resistance to falls and lateral loads: Good
  • Tested side load approx. 4.5kg.

Urgent notice:

Please note that the contact material between the pen and the stainless steel comes from the 3D printer. Therefore, it is important not to force the tip into the pen as it may be damaged when inserting or later removing. Never use pliers or similar tools to remove the tip as the pressure on the 3D printed part could separate the individual layers and damage the tip.

If the tip gets stuck:

If the tip is too tight so that it can no longer be pulled out by hand, it is advisable to carefully insert a sharp, thin object such as a cutter knife between the pen and the tip and gently pry the tip out.

Note about the product:
Our products are manufactured with the highest precision using the FDM process. However, due to the manufacturing process, minor optical defects cannot be 100% ruled out. However, we assure you that these irregularities do not affect the functionality and quality of our products.

Decorative items are not included and are for illustrative purposes only.